Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 3

Trial Purpose:

To screen potential cleaning products for removing paint/resin from steel parts

Date Run:

11/29/2007

Experiment Procedure:

Two products from the previous trial were identified for further testing on client supplied parts. While all 6 previous products showed potential, products were picked for more extensive testing based on performance, EH&S and possible cost considerations. Circular steel parts approximately 6 inches in diameter with resin on them were immersed in the two solutions of 100% concentration at room temperature, approximately 68F.

The parts were allowed to sit in the solution to determine what effect the cleaning products would have on the resin. Observations were made at 60, 120, 180, 240 and 300 minute intervals as well as overnight. Any signs of interaction between paint/resin and cleaner were recorded.

Trial Results:

Product Initial Appearance and observations
EnviroCare Floor  Clear fizzed with streaks of color
Stripper  
60 min soln was amber in color and resin was still hard
120 min Resin softening more. Can scrape off thin areas of resin on the side of the part. Solution darkening.
180 min Top layers softening. Can scrape more resin off. Solution was darker
240 min Same, top layer of resin softening and easier to scrap thin layers. Solution became dark.
300 min Same
overnight Solution very dark. Thinner areas of resin can be scraped and wiped off. Top layer of thicker areas is softening.
   
Green Solutions Clear
60 min Soln slightly amber in color so some dissolving. Resin softening on top
120 min Resin softening more, can wipe off top layer 
180 min Same. Resin softening on top layers, easy to wipe/scrape off.
240 min No change
300 min Thinner layers of resin down to the bare metal with wiping and scraping. Thicker areas of resin, ¼ to ½ inch, half gone as top layers soften.
overnight Same

Success Rating:

A follow up test, usually based on company input.

Conclusion:

Both the Rochester Midland and Spartan products worked. The cleaners soften the resin on the top which allows it to be wiped or scraped off in increments. These two will be tested warm, at 120F to see if this will speed up cleaning time.

Save Report as a PDF