Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 9

Trial Purpose:

To evaluate effective aqueous products on third buffing compound.

Date Run:

09/21/2005

Experiment Procedure:

Three products were selected from the lab's previous test results based on performance. Each product was used at 5% diluted with DI water and heated to 130 F on a hot plate. A 600 ml beaker was filled with each product and placed on a stir plate.

Nine preweighed 260 Brass coupons were coated with the Buffing - Jacksonlea ET-31A (1317-95-9) buffing compound. The compound was applied by heating the coupons and the buffing compound with a Master Appliance Heat Gun. The hot buffing compound was rubbed across the surface. Coupons were allowed to cool to room temperature and weighed a second time to determine the amount of contaminant applied. Three coupons were cleaned in each product for 5 minutes using stir-bar agitation. After cleaning, the parts were rinsed for 15 seconds in 120 F tap water bath and then dried for 30 seconds using dry, compressed air at room temperature. Once dry, final weights were recorded and efficiencies were calculated for each product.

Trial Results:

One product removed over 90% of the third buffing compound. The other two only removed around half of the contaminant. The lower efficiencies were recorded on coupons that had large clumps of the buffing compound. When the buffing compounds were applied in a thin layer, efficiencies were much higher.

Cleaner Initial wt Final wt % Removed
Fomula 815 GD 0.1602 0.0711 55.62
  0.2267 0.1133 50.02
  0.0615 0.0221 64.07
MC 132 0.1551 0.0096 93.81
  0.1240 0.0287 76.85
  0.1432 0.0006 99.58
Texolite 1740 XL 0.1643 0.1188 27.69
  0.1172 0.0647 44.80
  0.0271 0.0041 84.87

The drop-in solvents worked better than the aqueous cleaners. The table below lists the efficiencies for the drop-in solvents from the previous tests.

Product        Efficiency
Ensolv         94.66
CCA            91.74
MCA           81.60
Lenium ES      98.33
Solvon IP      79.47
Solvon PB      71.18

Success Rating:

A follow up test, usually based on company input.

Conclusion:

The next step of testing will be to evaluate the aqueous products using ultrasonic energy and to compare results to current aqueous cleaning product. Additional testing would be to clean client supplied parts.

Save Report as a PDF