Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 6

Client Number 155

Project Number 1

Trial Purpose:

Evaluating additional cleaners for removal of reed wax.

Date Run:

08/28/2001

Experiment Procedure:

One cleaner was tested based on client request. The solution was used at full strength. Uni-Clear, was heated to 100F in a heated water bath (due to its low flash point of 140 F). Six preweighed coupons were coated with the supplied Stacking wax (3) and the Crystalbond 590 (3). The wax and the 590 were heated with a hot air gun and a moderate layer was added to the coupon. These coupons were then allowed to cool to room temperature and weighed again. Three coupons were immersed in the cleaner. Observations were made at 5, 10, 15, 20, 30 and 45 minutes. After the final observation, the coupons were rinsed in DI water and dried using air blow off. Coupons were then weighed a final time and percent efficiencies were calculated for each cleaner.

Trial Results:

Of the two contaminants evaluated, only the wax was removed from the coupons. The wax was removed within 30 minutes, which was very consistent with the reed wax removal of 25 minutes. The Crystalbond 590 should no visual signs of being removed by Uni-Clear. Table 1 lists the calculated efficiencies for the two contaminants cleaned.

Table 1. Cleaning Efficiencies

Uni-Clear Wax 590  
Coupon 1 100.05 16.99 no change
Coupon 2 100.00 -0.17 no change
Coupon 3 99.98 0.32 no change
Average 100.01 5.71 n/a

Success Rating:

A follow up test, usually based on company input.

Conclusion:

Uni-Clear was found to be an excellent cleaner for both the Reed wax and the Stacking.  The cleaner was in effective in removing the Crystalbond 590.

Save Report as a PDF