Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 2

Client Number 79

Project Number 4

Trial Purpose:

To re-evaluate successful products at higher concentration

Date Run:

10/08/2002

Experiment Procedure:

Three products from the previous trial were diluted to 10% using DI water in 600 ml beakers. Each solution was heated to 130 F on a hot plate, followed by a 5 minute degassing in a Crest 40 kHz ultrasonic tank. Twelve preweighed coupons were coated with Fuchs Lubricants Co Renodraw 12 using a hand held swab. A glass rod was then used to ensure a thin, evenly distributed layer of lubricant, more closely matching actual operating conditions. Coupons were then reweighed using a Denver Instruments A250 Balance.

Three coupons were cleaned for 8 seconds in a cleaning solution, followed by an 8 second ultrasonic tap water bath rinse. Coupons were dried using air blow off at room temperature for 10 seconds. Once coupons were dry, final weights were measured and efficiencies were calculated.

Trial Results:

The increase in concentration caused the efficiencies for two of the products to decrease. Surface Cleanse 930 actually gained weight due to the thickness of the cleaning product. Only Inproclean 3800 resulted in an effective removal of the contaminant. Table 1 lists the amount of contaminant added and removed.

Table 1. Cleaning Efficiencies

Cleaner Initial wt Final wt % Removed
EXP 1400 0.0324 0.0079 75.62
  0.0544 0.0125 77.02
  0.0632 0.0214 66.14
Surface Cleanse 0.1173 0.0750 36.06
  0.0533 0.0822 -54.22
  0.0518 0.0809 -56.18
Inproclean 3800 0.0367 0.0005 98.64
  0.0258 0.0002 99.22
  0.03 0.0004 98.67

Success Rating:

A follow up test, usually based on company input.

Conclusion:

Only Inproclean showed improvements at 20% concentration.  The other two products, EXP 1400 and Surface Cleanse, worked better at the 10% concentration, removing over 93% of the lubricant.

Save Report as a PDF