Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 26

Trial Purpose:

To evaluate supplied product for carpet resoiling compared to industry standard product.

Date Run:

12/01/2005

Experiment Procedure:

Carpet pieces that were previously soiled and cleaned with DFC 105 (client product) and Liquid Formula 90 (industry standard product) were resoiled by placing the carpet sections into the 1-gallon can, making sure the carpet lined the inner wall of the can.  Nalgene® tubing cut into 1/8" pieces were poured into the bucket and 2 grams of the AATCC soil was distributed along the width of the can.  The can was lidded and placed into a harness attached to a crank shaft. The crank was turned at an average rate of 42 rpm by hand for 5 minutes in one direction, followed by 5 minutes of rotation in the opposite direction. At the end of the 10-minute soiling regime, the carpet was placed onto a carpet template and vacuumed with a Eureka SuperBroom (Brush-Up, Motor-Driven/Brush-Roll) vacuum for 5 strokes in the forward direction followed by the same number of strokes in the backward direction. The carpet pieces were evaluated again using a SPER Scientific Light Meter 840021 used to measure Foot Candles from the surface of the carpet. Visual comparison was also preformed to determine which product looked cleaner.

Trial Results:

The industry standard product resulted in higher post vacuuming light meter readings. Visually, there was no difference between the two carpet sections after resoiling and vacuuming. The table lists the average readings for each cleaner.

DFC Degreaser

Post Clean Resoil Vacuumed Difference Overall Ave Difference
6.5 2.37 2.58 0.21  
5.86 2.67 2.86 0.19  
5.62 2.99 3.19 0.2 0.2
         
Industry Standard Product      
Post Clean Resoil Vacuumed Difference Overall Ave Difference
4.4 2.13 2.59 0.46  
4.31 2.39 2.66 0.28  
4.9 2.87 3.26 0.39 0.28

Success Rating:

A follow up test, usually based on company input.

Conclusion:

The industry standard had higher light meter readings after resoiling and vacuuming indicating better soil rejection than the client product. Visual analysis by two lab personnel resulted in no difference in the two cleanliness levels.

Save Report as a PDF